All we do is often involved with our tenet ” Purchaser to start with, Rely on initially, devoting over the food stuff packaging and environmental defense for 2019 Latest Design China Custom Silicone Rubber Products Electronic Component for Keypad, Welcome to visit us at any time for organization marriage established.
All we do is often involved with our tenet ” Purchaser to start with, Rely on initially, devoting over the food stuff packaging and environmental defense for China Silicone Rubber, Electronics Components, Our company insists on the purpose of “takes service priority for standard, quality guarantee for the brand, do business in good faith, to offer skilled, rapid, accurate and timely service for you”. We welcome old and new customers to negotiate with us. We will serve you with all sincerity!

Installlation nstructions

Preservation:
1 Shaft outside diameter is within tolérance 0 comm
2.Shaft run out<0.1mm
3.Shat end float<0.13mm
4 No sharp edges on the shaft over the o ring
Note:
During the installation don’t scratch or damage the o ring . if anything is damaged , please contact with our local agents to replace a new one.

Installation in structions:
The full set of cartridge seal is cleaned and exactly passed leakage examine before sale.In order to avoid damage, don’t disassemble and clean the parts again before fixing.
2 The fitting allowance between the seal and shaft is dl h6 0.8, and there should be leading-inedge at the end of shaft. The outside diameter of shaft at the position of screw should be 01 -0.2mm smaller, resisting the screw over-tighten Lubricate the shaft with oil.
3. Place the cartridge seal into the pump chamber, then:
    A: Tighter four screw bolts of flanges, ensuring the medium leading in hole”Gat the top Position.
    B: Tighter four set screws and position the shaft sleeve on the shaft.
    C: Remove four gauge plates. Please keep them and they will be used in future installation and dissassembl.
    D Connect the medium lead-in pipe with hole”Gin order to flush away the friction heat and flushing the seal chamber when pump running.

Note:
After complete the installation, turning the shaft by hand to check for the rotation. If the shaft could not rotate smoothly, seal had been improperly installed.